(800) 853-2651
SHOP NOW

H bearing 8097D

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

D

David G

Well-known Member
I am looking for a new 8097D center steering bearing for a farmall H. Carter Gruenwald said these were no longer available. I really think I have seen them.

Any other ideas?
 
Kirk, I was thinking about that. I need to do same on MH 44, the
shafts are the same diameter. Would you try that with a drill, or
take to machine shop. I can turn bushings,
 
I took one to a local machine shop some years ago and they messed it up. Last one I did I drilled it out, little at a time and surprisingly it worked out. Another one I found a near new one at a salvage yard so that worked out well also. I have used copper water pipes in some places when I had problem finding bushings to fit. Don't remember if that was one of the spots or not but on these old tractors a lot of things need to be bushed, and built up etc.
 
Bore the housing and install the bushing for a center steering support on a 300 or 350 will work. But case ih has them priced ridicules now.
Piston pin bushing for A C175 engine works doing the same. May have to ream the ID just a tad. around $10.00 or less.
 
You must log in or register to reply here.

Similar threads

K
farmall parts & diagrams Farmall H Steering source
Replies
2
Views
182
Janicholson
Janicholson
J
IH 154 PTO shaft bearing
Replies
0
Views
70
John in Ct
J
R
Looking for complete belly pump assembly for 1940 Farmall H serial H21044
Replies
8
Views
470
BarnyardEngineering
BarnyardEngineering
S
1952 Farmall Steering Question
2 3
Replies
50
Views
2K
Jim Becker
J
C
Farmall H front tires
Replies
16
Views
760
caterpillar guy
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top