(800) 853-2651
SHOP NOW

Farmall 450 Gas PTO seal replacement questions

T

Tony_Idaho

Member
Hello,
I am trying to fix the last few leaks on my Farmall 450. When I cleaned out the PTO with diesel a few months ago, well it seemed to clean everything out fine and dandy, but now I have this leak from the seal. I think it would have been leaking before, but the 10W oil was so low inside the housing. now that it is filled to the correct level it leak.
My question: Can I just pry out the seal with a screwdriver, or is this a "more to it than that kind of deal"?
Do I need to remove the 3 bolts that are in the picture and take more stuff off to get to the seal.

Thanks
Tony
 
Mine had a small leak when I cleaned it up. I drained the unit and put half Lucas Hydraulic oil Booster & Stop Leak and half IH hi-trans oil.Thats been a year ago and it hasn't leaked a drop.
 
Forgot to add the picture... :)
5914.jpg
 
Looks like it might be the esiest to just take those 3 bolts out of the retainer and remove whole thing? drive the seal out the back Check the shaft for major grooving.(I doubt it its.)dress it with fine emery .

Get a new gasket for the retainer or cut one.
 
You must log in or register to reply here.

Similar threads

K
Float? Farmall 450 Hydraulics
Replies
3
Views
177
Brendon-KS
Brendon-KS
C
450 Sqealing
2
Replies
35
Views
839
used red MN
U
O
IH584 steering seal
Replies
6
Views
201
old
O
Ellis Kinney
PTO seal
Replies
13
Views
646
rustred
rustred
B
single front wheel Farmall questions
Replies
7
Views
443
DeltaRed
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top