(800) 853-2651
SHOP NOW

IH 2001 Loader and SH

I

IAtractorKid

Member
From what I can find, it seems the IH 2001 loader are pretty good loaders...is that the general consensus? How would that loader do on a SH w/an M&W live pump? I know mounting will take some fabrication (came off a 756) but would that make for a good combo or am I looking at too much loader for s SH???

What would be a fair price for a 2001 loader in fair condition with 42" manure bucket and 6.5' snow extension???

Thank you!
 
We had one on a SM worked fine, priced it to a guy for 1200.00 and he paid cash on the spot.
 
I bought a 2001 loader off of a M about 2 years ago now.. I gave 400 for it.. I put it on a D-17 Allis. Seems to be a sturdy built loader.. I'm happy with it, I just need a bigger bucket (mine is only as wide as the loader frame) and the tilt cylinder was pitted when purchased and has just started to leak in the last few months.

I'd rather have had a 2000 loader with the twin tilt cylinders (and a lot easier to get a wider bucket) but for the price, I'll keep using just what I got.. Beats the Kelley loader I took off the D-17 hands down!!

Brad
 
I'd have to look in my manual, but I believe the Farmall 350 is one of the tractors listed as "compatible" with the 2001 loader. If a 350 will work, so will a Super H.

Mounting on the SH won't take as much fabrication as you probably think. The frame rails are only 2" narrower than a 756.

Your biggest challenge is back at the rear axle. SH is square. 756 is hex shaped. I think the 2000/2001 had slightly different side frames for the two different tractors. Again, I'd have to look in my manual.
 
(quoted from post at 13:13:50 02/09/12) From what I can find, it seems the IH 2001 loader are pretty good loaders...is that the general consensus? How would that loader do on a SH w/an M&W live pump? I know mounting will take some fabrication (came off a 756) but would that make for a good combo or am I looking at too much loader for s SH???

What would be a fair price for a 2001 loader in fair condition with 42" manure bucket and 6.5' snow extension???

Thank you!
Click to expand...

It may not be a problem, but doesn't the torque make the 350 9 inches longer than the SH?
 
You must log in or register to reply here.

Similar threads

G
International 484 or case ih D45
Replies
2
Views
134
WESnIL
W
6
Farmall 504 Loader
Replies
1
Views
262
BarnyardEngineering
BarnyardEngineering
S
2001 IH Loader Question
Replies
6
Views
576
Stonewall68
S
8
560 loader search
Replies
7
Views
487
dhermesc
D
F
Wagner Loader
Replies
0
Views
140
fusion1
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top