(800) 853-2651
SHOP NOW

1086 turn signals

B

BKreiter

New User
I can"t get my turn signals or 4 ways to work on my 1086. I replaced the turn signal switch and still no luck. I have 12 volts to the switch and the head lights work. Any ideas would be a great help.
Thanks Brett
 
You said you had power into new switch. Did you use a tester on the out side of switch? If you did and have no power it has to be in switch. New switches have been known to be deffective.
 
Do you have the 12 volts at switch when it is turned on, all hooked up. You could very well have a poor connection at fuse holder that will show 12 volts to switch until you try to draw current then it may drop off. It is a separate fuse, not on main light fuse.
 
The 4 position light switch activates the flasher unit for the four ways. The turn signal lever activates the turn signals through the flasher unit.

Check to see if you are getting power to the flasher unit (attached to the turn signal lever under the dash) when you turn the light switch to the 1st position.


Sounds to me like your flasher unit is bad to me.

Gary
 
Pete23 you were right. I cleaned off the fuses and the flashers worked. I thought they got power through the head light fuse. Thanks a million. I"m located in south eastern PA and the traffic is getting crazy. The more flashing lights on the tractor the better.
Brett
 
You must log in or register to reply here.

Similar threads

C
IH 1086 Temp gauge
Replies
2
Views
172
Mrfred54
M
A
IH 1086 PTO drive bear replacement
Replies
2
Views
88
Ayden
A
I
No trailer lights or brakes on trailer
Replies
18
Views
775
Hemmjo
Hemmjo
J
ih 656 starter stuck after ignition off
Replies
5
Views
325
wore out
wore out
P
YM1500 Buttons and Switches?
Replies
1
Views
93
bmaverick
bmaverick
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top