(800) 853-2651
SHOP NOW

Farmall H Carburetor Question

6

68rs327

Member
I am about to order a kit to rebuild the Carb on my 1947 Farmall H, carb #50981DB.
I saw a photo of an "H" Carb and like the drain valve on the side of the Carb. Where can you buy a kit with a drain valve like this? I have looked everywhere with no luck.
CarbHDesktopResolution.png
 
I don't know if you can get it in a kit, but I have one like that that came on the carb my H had when I bought it and I moved it over to my "new" carb last spring because it was handy. I think that is a 1/8" pipe thread, so the part would not be specific to the carburetor and you might be able to find what you want at an auto parts store or a hardware.
Zach
 
Your picture is way to big for my slow dial up but you can buy the common radiator type drain valve at any good parts store and install it in a carb I have more then one tractor that has that
 
As suggested below, but be sure it is for fuel, some water valves have rubber and or plastic that will melt. Jim
 
In our area [Eastern Iowa] Farm & Fleet has these drain valves in the tire/ pneumatics section. Milton air products & they have 1/8 & 1/4 inch ones. I believe they are all brass. $2 to $3 is all.
 

I've got several of the original brass drain cocks. Some are good, some not so good. I remove them and replace with a pipe plug because I do not trust those draincocks to NOT leak when I do a rebuild.

Farmall H carb kits are all the same, and they all come from the same place except for the kit you can get at Case-IH for about $100.

I will also mention that ALL of the kits (except Case-IH) will have some non-fit issues and also very vague instructions. I know what the non-fit issues are, and I fix them before I send a kit out.
 
I have to disagree on this one. All kits are not the same. Not all kits have fitting issues. IH kits are probably the best but certainly not 'the' best. NAPA kits are of equal quality but are not complete. The kits from Steiner are right up there with IH in my opinion and cost a lot less. The kits from TSC are on the low end of the sale.
 
You must log in or register to reply here.

Similar threads

D
Farmall carburetor.
Replies
4
Views
373
used red MN
U
Q
Carburetor cleaning
Replies
12
Views
476
560Dennis
560Dennis
W
Farmall H Lead
Replies
9
Views
721
used red MN
U
1
Distillate E10 carburetor graphite
Replies
6
Views
235
rustred
rustred
N
farmall m carburetor rebuild
Replies
9
Views
483
ncems1995
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top