Anonymous-0
Well-known Member
Hey Fellas, if anyone could help me I need a wiring diagram for the 3 lights of a 330 utility, I have the Diagram for everything else but just not the lights, Thanks
- Thread starter Anonymous-0
- Start date
Janicholson
Well-known Member
a single 12 gauge wire goes from the bright /dim terminal on the light switch to the front, then splits to each light (solder and shrink tube the splice). The rear light hooks to the terminal with no resistor, it is on in both D and B with full volts. 12 gauge is best there as well. All lights are grounded through the mounts. Some get rusty and many have run a ground wire from the housing parallel with the supply wire and grounded near the light on the tractor casting or suitable good ground. Jim
C and G diagrams
C and G diagrams
Anonymous-0
Well-known Member
Thanks Alot!
Janicholson
Well-known Member
not a problem. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy