(800) 853-2651
SHOP NOW

Stanhoist Loader

I

IAtractorKid

Member
A couple days ago, I asked about the pitured loader for my SH. Was told that the mounting backets were not correct. I have found a set of mounting brackets for a Stanhoist loader off of a 560; are those the same brackets that would fit my SH? If not, what would be required to make the current brackets on the loader fit my SH? Guy said it was off an Oliver 88. I'm asking because I think the price is right on this loader and I cant find another Stanhoist like it anywhere close to me...

Thanks!
a58783.jpg
 
my stan.hoist loader was on a M then a 560 and a 706? before i put it on my A jd. if you use the 560 mounts i think that youll have no truble putting on your H. good luck Bob
 
The 560 frame rails are 2" farther apart than an H's frame rails, IIRC. The 560 is also quite a bit longer.

You will have the BEST chance of making it work with minimal modifications if you use the 560 brackets, though.

What you're going to have to do is try installing it, and see what you need to do to make it work.
 
460 or 560, same difference. Frame rails are still 2" wider and quite a bit longer.

Do the 460 loader brackets extend back to the axle housings?

If so, good news, because the axle mounting is the same on all H's, M's, Supers, 300/400, 350/450, and 460/560. You will have a good place to start from.

Bolt the brackets to the axles, and you'll probably need a 1" spacer up at the frame rail on each side. It should be fairly easy.
 
when i put that loader on my A jd i had to use 2 2in x 6in blocks to make the tractor wide enuff. i used 2 pices ot f20 frame rails cut to the right lingth. Bob
 
You must log in or register to reply here.

Similar threads

T
Looking for a loader for a 1959 model 730, wide front end.
Replies
10
Views
482
Tx Jim
Tx Jim
G
Mounting WL-40 loader on a 706
Replies
4
Views
365
fastfarmall
F
W
WTB loader 19-124 for 1958 Ford 961-5 (Row Crop)
Replies
1
Views
128
showcrop
showcrop
B
Farmhand F258
Replies
5
Views
298
brent!
B
M
Loader for Ford 3600
Replies
17
Views
868
ManaFarmandForge
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top