Belt pulley 1948 Farmall H

dcpky · Dec 24, 2011

The belt pulley is on 1948 Farmall H Thanks Guys

truckerlary · Dec 24, 2011

The housing assembly has to be removed. After you get it off there should be a snap ring holding the bevel gear on the shaft. removing that will let the shaft slide out of the housing. The shaft has to be removed to access the seal. Not a big job.

Nebraska Kirk · Dec 24, 2011

You don't need to remove the entire belt pulley gearbox to change the seal. Remove the bolts that are right behind where the pulley bolts to the flange, the shaft will then slide out. Remove the gear and bearings from the shaft and the you can slide the seal retainer off and change the seal.

Belt pulley 1948 Farmall H

dcpky

Member

truckerlary

Member

Nebraska Kirk

Well-known Member

Similar threads