# 37 disc bearings

Gene Popkes in SD · Dec 21, 2011

I have an early #37 10 foot tandem disc that had the front gang hangers and bearings changed to the later sealed bearings. IHC parts were used but are no longer available. If I go to Agri Supply for new blades, bearings, etc. for the back, what bearings and spools do I need? This disc is 7" spacing, but is the bolt 1" square? I am assuming I can rework the the hangers to take the newer bearing flanges? Suggestions & ideas please? Thanks, Gene

mike1972chev · Dec 21, 2011

Didi you check The Big Bearing store???

http://www.thebigbearingstore.com/discharrowbearing.html

That is where I am going to get mine.It will be next year before I can repair mine

Are your "hangers" on the rear FULL enclosed and use ALL 4 bolts to hold the bearings in??? I believe you can cut the bottom part off and just use the 3 remaining bolts??/ Hopefully someone else on here will help clarify this???

ejr-IA. · Dec 21, 2011

Mike is right torch off the bottom part and use 3 bolts a ih 370 or 480 disk use the same bearing as the 37.Ih should have the other stuff you need.

elkcagg · Mar 3, 2013

I know this has been discussed a while back but I have a #37 disc as well. Most of the bearings are shot and one gang locked up on me last fall. Am I better off converting this to the sealed type bearing, if possible, and what other parts do I need to adapt to this 14" disc? I found after market "spool" type bearings from Agrisupply.com and replacing 12 halves here plus the spools are going to add up. Also, as best as I can measure, it looks like a 1-1/8" square shaft on the disc. These aftermarket spools have a 1" square so I think I"m screwed here anyhow.

# 37 disc bearings

Gene Popkes in SD

New User

mike1972chev

Well-known Member

ejr-IA.

Member

elkcagg

Member

Similar threads