valve cover gasket

paul hansen · Nov 25, 2011

Where can I get a valve cover gasket for a 350 utility without buying the whole overhaul set of gaskets, thanks.

Allan in NE · Nov 25, 2011

Any parts store.

Get the neoprene type. Those cork things just aren't worth the hassle.

Allan

David G · Nov 25, 2011

NAPA or CIH

CNKS · Nov 25, 2011

???--I always use cork gaskets for the valve cover. I just don't tighten them too much, and have had no problems. And I don't use sealer, at least on the head side.

Anonymous-0 · Nov 25, 2011

I get gaskets from Case-IH and napa. I have used both cork and neoprene with good results with both of them. I put a light film of grease on both sides of gasket and tighten it down untill its snug.

David G · Nov 25, 2011

I put hi tack on one side of the gasket and on the cover so that it will not slide.

Tom Fleming · Nov 28, 2011

cork or rubber, both work fine. The valve cover gasket is the one that most people OVER torque, which crushes the gasket, and you end up with leaks.

Joe's Farmall should have them.

valve cover gasket

paul hansen

New User

Allan in NE

Well-known Member

David G

Well-known Member

CNKS

Well-known Member

Anonymous-0

Well-known Member

David G

Well-known Member

Tom Fleming

Well-known Member

Similar threads