drawbar

ajdeereman · Nov 23, 2011

I am looking for a drawbar to fit my super h i recently purchased. Will only a h and super h drawbar fit or will others if so what models. I no were there a couple m's for scrap

sflem849 · Nov 23, 2011

M drawbars are different. You can buy reproduction ones for just over $100. A good used one will fetch good money at a junk yard.

Allan in NE · Nov 23, 2011

M won't fit; not even close.

Allan

Zachary Hoyt · Nov 23, 2011

I sent you an email, I have an H parts tractor coming friday that I think has a good drawbar, I'll have to check.
Zach

karl f · Nov 23, 2011

my dad found a thicker than stock one piece off something newer that fit perfectly and the hitch points came out right. I'm guessing 504? It had to be placed above the horseshoe and held in place with a U bolt, but purchasing a roller and some torch or drill work would make it better.

karl f

Owen Aaland · Nov 23, 2011

The "U" shaped part of the drawbar will interchange although the one for the M is thicker.

Mark-Mi · Nov 24, 2011

Here is a M drawbar on my H. I had to slightly change the angle bends in 2 places to make it line up. I also have the M u shaped piece on. Holes all line up on the u piece same as on H.
I like the longer length of the M drawbar because I use a over run clutch on my pto.
Made a tractor out of it, the H drawbar is way to wimpy in my opinion.

Janicholson · Nov 24, 2011

The M drawbar is ticker and has a largwer pivot pin. The bends to place it at the pull point are different. The U shaped drawbar support, attached to the axles will interchange, but the M is (as noted below) thicker. Pulling point should be made to match the H length unless needed as noted below. Jim

drawbar

ajdeereman

Member

sflem849

Well-known Member

Allan in NE

Well-known Member

Zachary Hoyt

Well-known Member

karl f

Well-known Member

Owen Aaland

Well-known Member

Mark-Mi

Well-known Member

Janicholson

Well-known Member

Similar threads