HM-250 Cultivator Parts

IAtractorKid · Nov 7, 2011

Anybody got any parts or know where to find them for an HM-250 front mount cultivator on a Farmall H? I am in need of the following:

30742BA - PLUG, lift, hydraulic cylinder
PO27 - SPRING, hold-down (1-1/2" OD, 10" long, 33 coils)

Also, were the rear toolbars standard or optional? My cultivator did not come with any so wondering if I need to try and track some down...

Thanks!

Allan in NE · Nov 7, 2011

Ya sure you've got that thing mounted right? Seems way too far forward.

Yeah, the cultivagtor isn't much good without the rear gang.

Allan

IAtractorKid · Nov 7, 2011

Yep it only lines up to the frame in one spot!

IH fan · Nov 7, 2011

(quoted from post at 19:32:10 11/07/11) Ya sure you've got that thing mounted right? Seems way too far forward.

Yeah, the cultivagtor isn't much good without the rear gang.

Allan

I have seen people cultivate without dragging out the tire tracks. I agree it's probably better with the rear, but it's been done without it. Weeds seem to come back quicker and water errosion has a better place to start.

gene bender · Nov 8, 2011

Yours has the long tooling bars so there is a place for another shank. When you get your manual you will see that were different tooling bars.

IAtractorKid · Nov 8, 2011

I see what you mean...whith the No. 14 Tool Equipment, I should have eleven spring trips and be ok with no rear tooling as it says it was not regularly furnished with this setup. IIRC there are 8 on there now and the guy gave me an extra so I just need to track down a couple of those along with the other parts. Thanks!

HM-250 Cultivator Parts

IAtractorKid

Member

Allan in NE

Well-known Member

IAtractorKid

Member

IH fan

Well-known Member

gene bender

Well-known Member

IAtractorKid

Member

Similar threads