(800) 853-2651
SHOP NOW

Farmall 200 rear wheel spacing with plough?

T

tractorsam

Well-known Member
Hello, can anyone tell me what the approximate rear wheel spacing should be on a Farmall 200 for ploughing with a 2 point mounted two furrow plough? I haven"t had the tractor long and the wheels are hard in, we are having a local plough day tomorrow and I"m hoping to bring it but wanted to get some adjustments done first. Thanks, Sam
 
Hi Sam,

My SC is set with both wheels set in as far as they will go. Rears are full of water and 3 sets of weights. I do have a fast-hitch with a C-20 plow.
2nd pic is an early one before I set the other tire in. I thought I could get by leaving it at the "cultivator" width and only have to move one side. We got it done but it was a fight. It was hard to keep straight with one wheel in and one out.
a53040.jpg

a53041.jpg
 
Dean's Picture is great. If you are pulling a trailer plow, or a different mounted plow, the issue is to have the distance from the furrow wall to the colter on the first moldboard distance at (or just a little more (1/2 inch) than the moldboard size. Jim
 
Thanks to both of you. I left the wheels hard in and after a few adjustments had some fun and turned out a not indecent result considering the ground conditions were pretty horrific. Thanks, Sam
 
You must log in or register to reply here.

Similar threads

C
Change Rear Wheel Spacing on a Deere M
Replies
4
Views
477
ChrisInPA
C
R
IH 504 Utility Rear Wheel Spacing
Replies
5
Views
467
rustred
rustred
C
wheel weights on a Farmall 100
Replies
4
Views
2K
gene bender
G
B
2120 Rear Wheel Help
Replies
0
Views
363
Brads2002
B
T
Farmall M Transmission and Engine
Replies
5
Views
403
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top