got my C pulley today

souNdguy · Nov 1, 2011

while putting on a clean shirt before heading to night job, big brown truck dropped me off my pulley for my C.

can't wait till tomorrow afternoon so I can get into it..

as far as i can tell , crank shaft seal pushed out of the bacl of the cover, then is inserted from the back of the cover.. correct?

soundguy

gene bender · Nov 1, 2011

Yes the seal is installed from the rear. Before you install the new pulley better have someone do a good job of reading a mike on both the crank and id of the hole on the pulley.

souNdguy · Nov 1, 2011

bad rash of miss-made pullies out there in circulation?

soundguy

gregk · Nov 1, 2011

Yep pretty easy job, just make sure toleave the timing cover bolts loose until you get the pulley on the shaft so it gets centered right. If you have a manual it tells you all this anyway.

TedinNE · Nov 1, 2011

The seals from IH used to come with a wear sleeve. Make sure the hole in the timeing cover is large enough to clear the wear sleeve.

souNdguy · Nov 1, 2011

i got the oe wear sleave, and a speedi sleave. i must say.. the speedi sleave is much 'thinner' than the comparitively beefy IH one. however, BOTH will let the seal slip over them upon push thru test with a lil grease on the lip of the seal.

soudnguy

got my C pulley today

souNdguy

Well-known Member

gene bender

Well-known Member

souNdguy

Well-known Member

gregk

Member

TedinNE

Member

souNdguy

Well-known Member

Similar threads