(800) 853-2651
SHOP NOW

farmall 706 parking brake

The parking brake is a mechanical gear lock, a pawl inside the transmission engages the reverse gear, usually what fails is the linkage that operates it to engage or disengage, it is under the metal floor foot plate, the linkage has hex long adjusting nut with a rht thread L-link & lht L-link, common for lht end to be bent. You probably cant bend it back so it will stay, brittle metal. Get a replacement from Hi-Capacity, its spring loaded to minimize this.
 
well it all depends on what happened . IF it still has the old over center linkage then hopefully she is way out of adjustment. and it just jumped over the gear. BUT if it did not just jump over the gear and it took teeth off that gear then you are in for a lot of work . Tractor has to have a rear split and tires and wheels have to come off rock shaft housing needs to come off transmission coves have to come off and the list goes on as that gear will be the last out and first back in . Then when your done and before you put the top transmission cover on i would recommend that you install the new spring loaded park lock loc. Oh and always before you engage the park lock make sure that the transmission is IN neutral and your foot is OFF the clutch.
 
You must log in or register to reply here.

Similar threads

B
706 eng change from combine
Replies
7
Views
557
budaa
B
F
YT parts section. Is this also for the 706 ?
Replies
8
Views
634
FinallyFarming
F
F
Will 560 front end fit on 706 ?
Replies
6
Views
343
used red MN
U
F
Farmall 706 - Seeking Wide Front End - Mid Florida
Replies
5
Views
366
FinallyFarming
F
F
Need advice on the fuel line going to pump.
Replies
3
Views
247
rustred
rustred
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top