(800) 853-2651
SHOP NOW

A plow

A

Anonymous-0

Well-known Member
I have a plow for a manual lift A. I have everything I need except the one piece of steel that goes from the front control (depth) arm to the plow. If someone could give me a pic and some dimensions so I could make one it would be greatly appreciated. I assume it is a A-92 or A-192 plow.
 
I have a BN-187 and a B-187 Looking in the parts book the one for the A it would be around 20in long with 6 holes for the depth lever. The ones for the two plows i have are just 14in long but parts book shows your s should be around 20 the material is 1/4X 2IN WIDE. I can get the measurements off one i sold its 30mi north of me if you would like but the measurements i gave you would work just fine.
 
Thank you...just what I was looking for...I assume the piece is straight without any bends???...also the 6 holes will probably be located to one side and not across the whole 20"??..thanks again...once I get the plow clean enought to see some numbers I will get a parts book I just don't want to have extra unused books around is all...
 
Yes the holes are around 2in apart and the whole piece is straight it sets the draft of the point to make it deeper or shallow. A lot depends on how good your point is and soil conditionsm Mite want to heat the point and bend it down some so the plow will go in the ground better.
 
You must log in or register to reply here.

Similar threads

C
Adjusting an A193 plow
Replies
12
Views
527
BarnyardEngineering
BarnyardEngineering
K
WANTED: A-295 plow parts
Replies
1
Views
120
13fx
1
P
Cub Loboy front snow plow hook up question
Replies
4
Views
316
formerly ny bill
formerly ny bill
A
Does anybody know what this is?
Replies
5
Views
516
greg krush
G
D
Farmall B - plow (bracket?)
Replies
9
Views
492
DoubleJFarmsWA
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top