(800) 853-2651
SHOP NOW

farmall c clutch

K

ken p

New User
1948 C ? Push the clutch in fully, put in gear release clutch it will return to top position except for the last 1/2 inch of pedal. Tractor will not move. Start to tap pedal with foot and tractor starts to move. It will stop with clutch pushed in. Does it sound like a something needs readjusted? I use this tractor mainly for plowing snow in the winter. So in sets mostly in the summer months out doors. Any ideas.
Thanks Ken P
 
The pedal should have a clearance of about an inch or a fraction more. 1/2 is too tight. It does not fully return because the shaft is binding. Grease may help or you may have to remove it and clean it up. May not be easily removed without a split, you might try some penetrant on the inside, but keep it off the clutch, also hard to do. The clutch housing is probably full of mouse nests and manure, along with mud dauber nests.
 
Sounds to me like your clutch shaft splines are worn or the clutch plate is and is hanging up. Lub may help, but sounds to me like you need to split this and see what is going on.
 
I have the correct travel on the clutch pedal. You may have hit the cause with mouse nest interferring with the movement.
Thanks
 
You must log in or register to reply here.

Similar threads

R
Super C clutch pilot bearing
Replies
7
Views
386
Roger46
R
1
JD 4430 just stopped moving
Replies
10
Views
1K
Joe Stewart
J
F
Did the "mechanic" lie about my clutch too? Very dangerous condition
2
Replies
31
Views
1K
cleddy
C
M
Massey Ferguson 203 Workbull Industrial, need clutch replacement parts help.
Replies
11
Views
528
Stan Coryell
S
M
46 Farmall H clutch problem
Replies
11
Views
790
Baelee05
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top