(800) 853-2651
SHOP NOW

f20 hydraulic pump

C

chad mn

Member
i have a f20 hydraulic pump that i want to mount. i believe it is the pump for the lift all set up? does anyone have any pictures or info on how or what is needed to mount it? any help would be much apreciated.
 
do you have any pics of what you have? There is a drive coupler that takes the place of the nut on the front of the PTO shaft. There is a flat plate that bolts to the trans at the place where the trans input housing and pto shaft cover go on front of trans. A housing bolts on where the cover was at front of pto and hydraulic pump and reservoir bolt to that. I will have to dig and see if I have any pics on my computer of that or not. Otherwise it will be the weekend before I can go out and take some.
 
(quoted from post at 05:39:03 09/12/11) i have a f20 hydraulic pump that i want to mount. i believe it is the pump for the lift all set up? does anyone have any pictures or info on how or what is needed to mount it? any help would be much apreciated.
Click to expand...


if you have the rear powerlift that bolts on the rearend cover, you dont need a pump. they run off the rear PTO shaft
 
Is this the setup you have? this isn't all of it but the only pic I could find.
a49068.jpg
 
you see the drive coupler on the pump, you need the other half that goes on the tractor to turn the pump. There is also a flat plate that bolts to the front of the trans around both the lower(pto) shaft and the center (input) shaft. The part you see there bolts on to the plate and around where the bearing cover on the ft of trans for the pto shaft was, you must remove it to install drive and then the pump assy. I would say the flat plate is a reinforcement. I will try to get more pics this weekend and put up a new post.The other half of the drive coupler takes the place of the nut that is currently on the front of the pto shaft behind the cover.
 
You must log in or register to reply here.

Similar threads

L
F20 McCormick Deering Farmall Pedal Tractor
Replies
1
Views
276
Fritz Maurer
F
L
Farmall F 20
Replies
14
Views
495
F-Dean
F
T
484 hyd/slipping issue
Replies
12
Views
255
JimB2
J
J
hydraulic pump rebuild
Replies
4
Views
287
JustIH
J
J
Help Identifying function in hydraulic pump
Replies
3
Views
217
JustIH
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top