Purchased new power adjust rims and new tires for my 504 utility. The holes in the rail where the rail stops go are farther apart than the origional rims, so the stops cannot be snugged up tight. Is there a fix for this or do I take the whole business back to the tire dealer?
- Thread starter Johann II
- Start date
Janicholson
Well-known Member
If original equipment will not fit on a component purchased in good faith to be correct, it is their problem. If the stops will not tighten, what else is incorrect that will cause looseness or failure later (such that it becomes your fault!)
I would photo the component, and its wrongness clearly and take them to the dealer. They should come out and look at the issue and provide a satisfactory answer. Get the issue documented and have it fixed. Jim
I would photo the component, and its wrongness clearly and take them to the dealer. They should come out and look at the issue and provide a satisfactory answer. Get the issue documented and have it fixed. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy