FarmAll H

Dean Trent · Sep 6, 2011

how to get bottom shaft out of trans that runs pump the seal is bad Thanks Dean

hoof print · Sep 6, 2011

remove cotter pins on each end of shaft, slide collars back, remove.

Oldiron29 · Sep 6, 2011

Dean, If it is the front seal you can do a seal change under dust cover at the pump input shaft.
oldiron29

David G · Sep 6, 2011

If I remember right, the slotted end shaft screws out of the inner shaft. It is larger than the seal, which is on the inner shaft. Put the tractor in gear, pull coil wire for safety, then put a slotted bar in the groove and screw out. It is right hand thread, so left to loose.

Janicholson · Sep 6, 2011

Exactly correct! It is really tight, a 1/2 inch square bar placed into the slot, and about 3' long when pushed with your feet (trans in High gear, brakes on or wheels blocked) will be an expected mode! Jim

FarmAll H

Dean Trent

New User

hoof print

Member

Oldiron29

Well-known Member

David G

Well-known Member

Janicholson

Well-known Member

Similar threads