Farmall / Pete23

Rick MacGregor · Sep 6, 2011

Thanks for all of your help! Yes, the manual says (3) 3/4" long bolts, will do that. I could not figure out how doing that would seperate the pieces, but I have never had one apart before now. Everything else on the tractor is straight forward.

Janicholson · Sep 6, 2011

The bolts push in on the PP components compressing the springs taking pressure off of the Disk, and unloading the TA from the pressure applied on the other side of the disk. Jim

Rick MacGregor · Sep 6, 2011

Thanks Jim, I was assuming that this would come apart the same as a typical clutch/PP, is there something diferent with this one that somehow prevents the TA from just sliding out? Also, can I just tighten the 3 bolts, ot do I need to compress the PP, and THEN tighten the bolts?

Rick.

Janicholson · Sep 6, 2011

IIRC just tighten them. Then remove the 6 PP bolts to gwet at the disk. Jim

Owen Aaland · Sep 6, 2011

The three bolts compress the levers so the PPA is thin enough to come between the TA shaft and the housing.

Farmall / Pete23

Rick MacGregor

New User

Janicholson

Well-known Member

Rick MacGregor

New User

Janicholson

Well-known Member

Owen Aaland

Well-known Member

Similar threads