1066 FEL connection

ridgelane · Sep 5, 2011

I would like to know if its possible to tap into the hydraulics of my 1066 with the joystick for my front end loader, without having to use one of the rear remotes.

Aces · Sep 5, 2011

ridgelane Yes it is cald a power beyond block, goes under the seat. you will have to change the left valve so as to add the block. Not cheap.

ridgelane · Sep 5, 2011

Thanks, but where does this power beyond block connect to and what kind of changes does one need to make to the valve? Is this a bolt on block that is added to the existing valve?

Janicholson · Sep 5, 2011

The block allows remote valves to be hooked up with tube or hoses. It should have directions on installation if new, or from the previous owner if used. Not complex. Jim

Aces · Sep 6, 2011

rideglane. Let me go back to the 706 806. The remote valves under the seat were the same valve for left or right remote, with an end plate. Later on the 756 856 the right hand valve remained the same but the left valve had end plate as part of valve. So if a person needed power beyond as you would like. Then the left valve had to be removed and a new valve was needed so the ports would go through the valve body and the power beyond plate could be added. Maybe could find a good valve off any 706 through 66 tractor if it was right hand valve, but would still need power block. you could email me [email protected]

1066 FEL connection

ridgelane

Member

Aces

Member

ridgelane

Member

Janicholson

Well-known Member

Aces

Member

Similar threads