(800) 853-2651
SHOP NOW

Super C Motor surging

J

Joe P.

Member
Adjusted governor per manual, motor still surges, adjusted bumper spring down and up 1 flat at a time, motor does not respond to any adjustment.
 
The bumper spring could be jammed up with crud or broken. That was the case on my SA when I rebuilt the governer.
 
The rod is free from binding. Manual says set governor control to 3/4 remove rod adjust so pin fits freely, turn yoke out 1 turn reinstall. Does that sound correct? I think or I hope this is the last hurdle I have before disassembling and painting. I want to make it right before paint
 
Improper fuel mixture can cause the engine to "surge". Might want to fiddle with those adjustments to see if it makes a difference.

Make sure you have good gas flow to the carb while you're at it.

Unfortunately a blocked path in the carb can have the same effect - but I'd try playing with the mixture screws before thinking about cleaning out the carb.
 
I did rebiuld the carb and did have on the initial start up 1 little piece of crud go right to the main jet and clog it. I think I will disassemble it again. My manual I bought has everything on rebuilding the motor and carb but the pages for adjstment for carb are not there maybe my initial adjustments are not right, I do notice that the motor does not respond to the idle adjustment
 
Many knowledgeable people here that can help you with adjusting carbs.

Try a search, I know I've seen several detailed explanations recently.
 
Many knowledgeable people here that can help you with adjusting carbs.

Try a search, I know I've seen several detailed explanations recently.
 
Problem solved! For some reason rocker shaft had a slight binding in it which I didn t notice when I cleaned it, Had another governor housing put that on BINGO no surging. Thanks for the help!
 
You must log in or register to reply here.

Similar threads

G
Super A governor adjustment
Replies
5
Views
329
560Dennis
560Dennis
C
Super C Clutch Adjustments
Replies
16
Views
369
cdd
C
B
Radiator Empty and Tractor Surging for Super C
Replies
4
Views
255
Bookman
B
W
governor 77 gasoline
Replies
2
Views
254
KLPinNC
K
S
8N Governor issue?
Replies
8
Views
527
ShawnPalichuk
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top