IH hydraulic cylinder repair

b-rad · Jul 12, 2011

Have a IH asae standard hydraulic cylinder 2"bore 8"stroke 7/8-14 threads, single acting cylinder that i want to put new packing in. I caint seem to get it apart got retaining clip out and tried spinning it thinking it would thread into the cylinder housing but need some help. thanks brad

DeltaRed · Jul 12, 2011

There may be a setscrew ,holding on to a groove in the gland.

pete 23 · Jul 13, 2011

There are two types like that I am familiar with. One , you take snap ring out of groove near top of cyl by turning it out through that groove and it sounds like that is the one you have. They wear a groove above snap ring making it difficult to pull apart but you have no other choice than pull rod out. Like hook on with a tractor.
The other style have a snap ring on the bottom of piston and you go through the inlet port and push snap ring off.

IH hydraulic cylinder repair

b-rad

Member

DeltaRed

Well-known Member

pete 23

Well-known Member

Similar threads