(800) 853-2651
SHOP NOW

h missing

A

Anonymous-0

Well-known Member
i got my h to run but it has a light miss it was out of time a little but not sure why it is missing i need to find some information on the way the caps is suppose to have the plug wires i was thinking 1324 i timed it with #1 at top dead center thanks for any help
jerry
 
I think the firing order is cast right into the block on some of my tractors. Maybe it wasn't the Farmalls though... If I were you I would check
 
It is definitely cast on the block, but it is 1342, not 1324.

2 1
4 3: rotor rotates clockwise when viewed from the rear.
 
The firing order cast into the block on the engine is, 1342,
However the cylinders are numbered from front to back. If you look at the cap from the rear, the wires go CW:
2-1
4-3
Best of luck. Jim
 
(quoted from post at 09:50:07 07/09/11) ok, it was there, gone now. who's playing tricks.
Click to expand...

I thought you were nuts. I backed out and went the the topic three down to see if that is what you were talking about.

I knew it was cast into the block on my MD, but that is a different bird than other stuff. I remember that because it is different than the norm.
 
You must log in or register to reply here.

Similar threads

1
Help IDa tractor I bought
Replies
14
Views
667
used red MN
U
F
H- gas tank
Replies
6
Views
415
glennster
glennster
T
Farmall 460 missing under load
2
Replies
21
Views
2K
tracker1961
T
H
jD 4219 missing at idle
Replies
7
Views
262
Harveylogging
H
3
FINALLY, Got the H running great
Replies
12
Views
757
rustred
rustred
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top