in-too-deep
Well-known Member
3 pt. wasn't functioning properly. It would only lift with the remote lever. Was informed here that the unloading valve is to blame.
Cover off.
Snap ring out
Plug out.
Piston out.
Now, do I need to take the ball seat, ball, spring out too? Is that where my gunk/rust is causing the trouble?
If I do have to take seat out...HOW do I get the valve/cylinder assembly out? I've been able to get this far without removing the valve. Don't think I can unscrew that seat while its in the tractor. I+T is worthless to me. Please advise. Thanks a million! Always amazed at the knowledge here.
Also, should I go ahead and remove that tall drainplug/standpipe to prevent leaks while I'm in here? Thanks!
Cover off.
Snap ring out
Plug out.
Piston out.
Now, do I need to take the ball seat, ball, spring out too? Is that where my gunk/rust is causing the trouble?
If I do have to take seat out...HOW do I get the valve/cylinder assembly out? I've been able to get this far without removing the valve. Don't think I can unscrew that seat while its in the tractor. I+T is worthless to me. Please advise. Thanks a million! Always amazed at the knowledge here.
Also, should I go ahead and remove that tall drainplug/standpipe to prevent leaks while I'm in here? Thanks!