(800) 853-2651
SHOP NOW

IH engine bolt patterns

F

farmallboy15

Member
i know an engine from a 460 would bolt up to a H and a 560 would go to an M, correct?? with a possible frame extension necessary. i kind of want to put a diesel IH engine in a letter series tractor. what frames would the diesel from a ?484? bolt to? i know where one is that a garbage truck broke in half.
 
No to both questions unless you want to do a LOT of fabrication. Anything is possible but not always practical.
 
The engine itself, NO.

However, if you add the front and rear engine covers, and the frame rails to the equation, then YES.

At the bell housing, an H will mate up to a 460. Same for an M and a 560.

Once you get away from that lineage, all bets are off. Basically anything after 1963 is a completely different animal except for the 656/666/686 line.

Definitely not a 484. Those are "frameless" tractors made in Doncaster England. Completely different family of tractors. Nothing mates up except to newer/older versions of the 484 (i.e. 464, 485, 495, 3210).

It CAN be done but it's all fabrication. Personally I would use a bigger 4-cylinder diesel than one out of a 484.

...and where would they use a little 35HP diesel in a garbage truck???
 
You must log in or register to reply here.

Similar threads

W
B414 cylinder head ferrule
Replies
8
Views
317
Fritz Maurer
F
D
IH 3514 Diesel Clutch Replacement (Bacckhoe)
Replies
4
Views
419
used red MN
U
M
  • Question
IH stationary engine identification and overhaul advice
Replies
13
Views
633
rcmedic
R
W
IH 434 Steering
Replies
9
Views
713
WPM
W
E
Ih 460 diesel utility
Replies
4
Views
352
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top