super H sleeve

Anonymous-0 · Jul 1, 2011

ordered one sleeve for super H farmall part#rp366748r1 and piston # 367010r1-b should be standard sleeve wouldnt fit down in hole to flus up with block, Is this the wrong sleeve or what, the lip was to thick and liked about 1/16 goiung down? help if you can.Were might I get right one??????

rustcollector · Jul 1, 2011

Rick,

Was the block/dry sleeve step clean? The sleeve is most likely the correct sleeve. Getting within 1/16 inch seems to point to the step not being cleaned or the sleeve not fully inserted? It will be slightly raised above the block surface, but the head gasket should take care of the extra height. 1/16 inch is too much above the block. Don't know if you can remove the new sleeve without damage or not. If you have to remove the sleeve, use a wire brush in a drill or Dremmil and polish the step. Then wrap the sleeve and put in a freezer overnight. Just before you are ready to insert the sleeve, use a heat source to warm the block. A sun lamp works well. Coat the sleeve with recommended product to lock it into place and drop it into the block before it warms up. Use a brass drift and hammer to gently (light taps) seat the sleeve all the way before it warms.

Owen Aaland · Jul 1, 2011

Always check the sleeves before installation for flange fit by putting them in the bore upside down. They should drop all the way in without any interference.

Anonymous-0 · Jul 1, 2011

got the sleeve back out without damage,took a long time and patience, took back to the place I bought it from suppose to get a refund. Gona go to international for the next one and will check lip upside down like the man said before installing thanks, but dont really know were to get the right sleeve.

El Toro · Jul 1, 2011

Are there any letters stamped into the engine block near the holes in your block where the sleeves are installed? Hal

Anonymous-0 · Jul 1, 2011

Anonymous-0 · Jul 1, 2011

the step in the block was clean

Pat-CT · Jul 1, 2011

Is it possible ( Im no expert in super series) That you have a plain jane H block? Im not sure if the bores were changed for the super H however.

rustyfarmall · Jul 2, 2011

(quoted from post at 20:08:54 07/01/11) Is it possible ( Im no expert in super series) That you have a plain jane H block? Im not sure if the bores were changed for the super H however.

Yes, the bore in a C-164 Super H engine is larger than in the C-152 H engine. A super H sleeve will NOT fit into a regular H engine.

Pat-CT · Jul 2, 2011

Is it possible, That this gentleman has a plain H block then.

rustyfarmall · Jul 3, 2011

(quoted from post at 17:21:55 07/02/11) Is it possible, That this gentleman has a plain H block then.

I don't know, but he did say the sleeve fit in the bore, but just wouldn't go down far enough. A Super H sleeve is enough larger that it won't even begin to fit into the bore of a C-152 Farmall H engine.

sflem849 · Jul 3, 2011

Maybe the service manual or I&T manual would have more info on sleeve fit?

super H sleeve

Anonymous-0

Well-known Member

rustcollector

Member

Owen Aaland

Well-known Member

Anonymous-0

Well-known Member

El Toro

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Pat-CT

Well-known Member

rustyfarmall

Well-known Member

Pat-CT

Well-known Member

rustyfarmall

Well-known Member

sflem849

Well-known Member

Similar threads