Farmall 400 Question

caseman-d · Jun 23, 2011

I been working working on a farmall 400. Started with a in-frame overhaul. After 5 years I got the engine back together and running fine. Now I have some serious hydraulic leaks. One is the manifold lines from the pump to the hydra touch. It appears that one line broke and they tapped a hose into it and replaced with hose, parts book didn't show any orings where the manifold bolts to the hydra system.

Second is the pto keeps getting over full and spilling out the breather tube. I assume there is a seal between the pto and trany housing. Any quick fix to either problems.
caseman-d

scott mcintosh · Jun 23, 2011

First of all there were two styles of hydraulic lines,one was all steel tubing and the other is hosed near pump like yours but o-rings are the same for both,pull line off and any good implement dealer should be able to fix you up if there is no CIH dealer near you.As far as pto problem you have drain transmission and pull pto out and replace shaft seal,parts not exspensive.Scott

Farmall 400 Question

caseman-d

Well-known Member

scott mcintosh

Member

Similar threads