(800) 853-2651
SHOP NOW

F-12 Clutch peg

T

Tom Fleming

Well-known Member
Does anyone know if the peg that the clutch peddle mounts on is threaded into the frame rail, or is it a press fit? Welded? I am guessing it is threaded in, but don't have it cleaned up enough to tell yet.......thought I would ask.

Mine is worn badley, and was looking to remove it and build up with weld, and turn back down......I guess a bushing is also an option.
 
That "peg" is press fit into the side rail. I found a local shop that had a 50 ton press. They pushed out the old one and installed the new one. On one of mine they had to apply a little heat. Pins are available from Rice Equipment.
 
On my W-30, I laid a couple beads of weld on the worn spots and ground/filed/sanded them smooth & true. Bushed the hole in the pedal too.

Worked fine.
 
thanks guys. This is the tractor I am taking to shows this year, last year, it was the F-20. so, I am working to get it up to snuff.

Appreciate all the feedback.
 
You must log in or register to reply here.

Similar threads

W
Farmall F-12 Losing Prime
Replies
5
Views
299
Athol Carr
A
W
Case 1490 water pump pulley
Replies
4
Views
262
Wetherdad
W
O
Wear on Front axle pivot
Replies
11
Views
882
onetotaltoolman
O
W
Farmall F-12 No Spark
Replies
10
Views
733
wowsk
W
J
Case 430CK overhaul, no start and stuck clutch.
Replies
7
Views
836
Joe (Wa)
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top