(800) 853-2651
SHOP NOW

IH 240 Utility/Farmall brake petal shaft oil seal replacemen

A

Anonymous-0

Well-known Member

Hello! I have a 240 Utility that I am rebuilding/restoring. I was getting ready to prime the "frame" and was moving the tractor into position when I noticed Gear oil on the floor. I traced it to the oil seal on the clutch(left)side. I dug out my TC-53B catalog and found that I need part#360-076-R92. The diagram only shows the right (brake) side of the tractor. This is the brake petal shaft oil seal...am I to assume that the clutch side takes the same oil seal? I could'nt find anything for the clutch side in the catalog.
Also, What is the procedure for replacing the seal? It is evident that one wouldnt completely remove the shaft unless they are a glutton for punishment.
Thanks for your help!
David
 
(quoted from post at 13:42:35 05/26/11)
I dug out my TC-53B catalog and found that I need part#360-076-R92. The diagram only shows the right (brake) side of the tractor. This is the brake petal shaft oil seal...am I to assume that the clutch side takes the same oil seal? I could'nt find anything for the clutch side in the catalog.
David
Click to expand...

If you will notice under the number required, it has a "2".
 
Yes, I see it now...I was focused on item #8. NOW I see item#10. Thank you, I just learned something new about this catalog.
Now, I just removed the seal on the clutch side...I had to gently drift the shaft into the case. I had to use a dremmel to split the seal and pry it out. I am hoping that the same can be done to remove the other side. To install the new ones, I think I'll drift the shaft to the outside, grease the shaft lightly and push the new seal on the shaft and then use a deep well socket and a small ball peen to seat it. What do you think?
 
You must log in or register to reply here.

Similar threads

C
TO30 Input shaft oil seal
Replies
3
Views
655
Jim.ME
J
M
Super M Clutch/ brake shaft seal number ???
Replies
6
Views
789
mike1972chev
M
R
Brake shaft oil leak
Replies
6
Views
2K
Oregon Tractor Jack
Oregon Tractor Jack
A
IH 460 Utility Hydraulic leaks
Replies
6
Views
1K
AC_IH_MF
A
T
Oliver 60 oil seal removal
Replies
4
Views
734
super99
super99
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top