(800) 853-2651
SHOP NOW

Which 706 carburetor and what does new one come with?

I

IH Tinker

New User
I need a new (or rebuilt) carb for my 706. My 706 was made in 1967, but I don"t have my serial number handy. The carb that was on it appears to be the wrong one? The metal plate is stamped "396198R91", but this appears to go to a 756.

There are 3 different carbs listed on ytmag.com for a 706. How do I know which one I need?

And what do the new (rebuilt) carbs come with? Do they come with the float, needle, throttle shaft, and the fuel shutoff solenoid, etc?

Thanks in advance for your help!
 
I just looked in IH parts manual and it shows 396197R93 as being used on both the late 706 with the C-291 engine and the 756. No 396198R91 listed. That doesn't mean there isn't one, just that I didn't see it. I guess what I am saying is that the 06 and 56 use same one if 706 has the C-291 engine which a 67 model would have. New carburetors would be complete except I cannot speak for the electric shut off.
 
Hey, thanks for the quick reply. I appreciate you looking that up. Sounds like it's not unreasonable that I have the carb that I do. It is in fact a C291 engine in my tractor. I just had new pistons, sleeves, input gear, camshaft, lifters, and some other parts put in it, so it's on it's way to running like new....just need a good carb.

So is there an advantage to using one over the other of the two carbs you listed? Should I stick with the same carb since that's what was on it, or would it make any difference if I put in the first one you mentioned that was common in the late C291's?
 
I can't find the number you posted so don't know what that number carb is for. If you are getting a new one I would get the one listed for the 706 with C-291 which is same as 756.
 
Ok, thanks. I'm picking one up tomorrow at the local tractor store that is a replacement for the factory original one you listed.

Thanks for all your help again, I appreciate it!
 
You must log in or register to reply here.

Similar threads

G
Almost too embarassed to post again TSX 706
Replies
16
Views
1K
JMOR
J
G
Almost too embarassed to post again TSX 706
Replies
15
Views
1K
JMOR
J
M
Ford 861 Carb Tuning
Replies
6
Views
339
mcashatt
M
F
706 Farmall fuel cut off solenoid repair
Replies
3
Views
279
used red MN
U
K
Cheap Carbs
Replies
11
Views
734
JMOR
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top