Case IH 900 cyclo planter

Don Anderson · May 20, 2011

I know this is a little off topic but hope someone can help. I have a 900 cyclo planter and last weekend I was finishing up planting when the drum quit turning. I do not have a monitor so have to keep a close eye on the drum to make sure everything is working. Looks like the clutch on the drive wheel needs adjusting since the hex shaft is not turning. Looked in the manual and it was not much help. Can anyone tell me how to get the clearances set correctly? Thanks.

Brownie 450 · May 20, 2011

You'll have to get a new clutch probably. Ours quit again this year, & the 2 halves come close to $100. Get the washers for both ends. We used to grease ours daily--wrong thing to do. Parts guy said 1 shot of grease per year. Check the spring before getting parts-- ours was worn on 1 end.

Don Anderson · May 23, 2011

Thanks. Any suggestions on how to adjust the spring with the spacers?

Case IH 900 cyclo planter

Don Anderson

Member

Brownie 450

Member

Don Anderson

Member

Similar threads