The ole H is in need of new bushings in 5th gear it has the death woble so I found a complete top bolster that came off a tractor that had a wide-front end most of its days it seams good and thight. My question is ..... can i safely block up the tractor say around under the bell houseing-belly pump and remove the hood,stering shaft,nose sheet metal,drain and remove the rad, lower bolster, Then try to remove the upper bolster with out the engine falling in the fram fails or looseing them???? I know the upper bolster is heavy I can use my "cherry picker" to lift it ok just wanted to know how you all would do it
Thanks
Thanks