EARLY IHC Steel Wheels- ID and Value

Had a pair of these wheels on our ranch, about 4 1/2ft tall by 1ft wide(pop can in pic for scale). From the book "150 Years of IH" they look to me most like the front wheels off a Titan, built in the teens. There's "IHC" cast into the center caps and also the center part that the spokes are rivited to.

Was curious what the collector(not scrap!) value of a pair of these would be? Couldn't be more than a couple dozen sets left in North America that didn't get turned into tanks for WW2???

These wheels were rigged onto a homebuilt stackmover here on the ranch years ago(30's), and a while back when we were cleaning up the place I moved 'em over a hill to a place where I was putting stuff I wanted to keep. The reason I say we "HAD" a pair of these was because this morning my #*$@$%# brother torched the rim off one of them so he could make a "fire ring"....GRRRRRR!!!!! Just curious how much that fire ring actually cost?
id51118.jpg
 
Ron, I can't tell from picture if axle is splined or keyed? Is there a big nut on the end of axle? Smooth wheels with small studs where sometimes called fairway wheels. A couple more close pictures please. oldiron29
 
These weren't "drive" wheels, the axle shafts themselves were fixed, in other words the wheels spin on the axles like there's a bearing or bushing inside them. The "center cap" thing, that's under the pop can in the picture, has a bolt going through it to hold it on the axle shaft. The "inboard" portion of the 3ft long axle has a keyway ground in it, probably 10in long....but of course I'm not positive those are the original axle shafts. Each wheel has(had) an identical shaft.

I'll try to get a closeup shot of the centers. Thanks!
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top