(800) 853-2651
SHOP NOW

Farmall H Axle Bearing Replacement

A

Anonymous-0

Well-known Member
You guys are probably going to get tired of me asking the "how do I" questions, but this is my first restoration, so my apologies in advance. 1951 Farmall H, pulled the rear axles and want to replace the inner and outer bearings as well as the PTO bearing. How do I get the axle shaft and bearings out of the axle casing. Removing the bearing retainers was of no help. What am I missing? Thanks! Greg
 
You are missing the bull gear, it is held on the end of the axle with a bolt, you have to remove that bolt and then the axle will slide out of the bull gear.
 
Thanks for the quick reply. Sorry I wasn't clear in my question. I have the axles off the tractor, I'm trying to get the axle shaft out of the casing so I can replace the bearings. There are four bolts that hold two half moon shaped retainers on the end that attaches to the bull gear. Removing these parts doesn't seem to do anything for allowing the shaft to come out of the casing. Any ideas? Thanks, Greg.
 
Look at what would be the outside end of the axle housing, there is a bearing cap there held on with 4 bolts, remove them and then the axle will come out.
 
Excellent link Randy...WELL DONE !! I know how much work that really is, you did a fine job, thanks !!
 
You must log in or register to reply here.

Similar threads

Z
Farmall 656 transmission overhaul--should I replace bearings if they seem ok?
Replies
7
Views
489
Greg Reed
G
R
remove inner axle bearing ?
Replies
1
Views
372
Janicholson
Janicholson
M
Super A wheel axle retention
Replies
1
Views
370
Jim Becker
J
R
which way around for bearings ?
Replies
5
Views
507
riverbend
R
D
MF 165 1968 Rear axle outer bearings
Replies
0
Views
415
Dusty Drake
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top