WAYNE A JOHNSON
Member
Is it possible to rebuild a Hydraulic pump on a 140, and if so, where could I order the parts?
- Thread starter WAYNE A JOHNSON
- Start date
Your Case/IH dealer should have the parts. Your Napa store may also have the parts. Hal
PS: Probably similar to the Super C & 200 series tractors. Here's a pic of the Pesco pump of the parts breakdown. You may need a speedi-sleeve kit if there's a worn groove from the old seal.
PS: Probably similar to the Super C & 200 series tractors. Here's a pic of the Pesco pump of the parts breakdown. You may need a speedi-sleeve kit if there's a worn groove from the old seal.
Anonymous-0
Well-known Member
Make sure the screen is clean and in good shape ! Filter screen stopped up hyd. system will not work right .
Get your check book ready when you go to the IH dealer. Mine about drove me crazy. I replaced the 2 rubber O rings and put it all back together, only to have it go out again. The gears wear out and the oil bypasses the pump past the gear shafts and enters the engine. The IH dealer wanted like $650 for a new pump and $450 for a rebuilt one. After dumping about $300 in parts I bought one from a tractor dismantler, for $150 and thank goodness it was good. I grew to hate my 140 and sold it shortly after.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy