(800) 853-2651
SHOP NOW

Super H Transmission

B

bcvining

New User
My father-in-laws '53 Super H has been making a noise in the front part of the transmission, We tore it down and found the front bearing as well as the pilot bearing bad.We have the front shaft out.My question is
if there is a little play, about a half inch or so ,in the main or pinion shaft, Do we need to finish tearing it down to get to the rear bearing or is this normal because we have the front shaft out?
 
Main shaft will have some side to side or up and down movement at the front with input shaft removed. Forward and back or very much back and forth rotation would be a cause for concern. Although the main shaft gear backlash can't be acurately checked unless the input shaft is in place with good bearings. May also be a good idea to remove the pulley gear box or cover to check for any pieces that may have fell to bottom of housing. also can help when installing the input back in.
 
Thanks! We have removed the pulley gearbox and I think we will remove the top plate just to get a look at the rear bearing. Thank's again JRV
 
You must log in or register to reply here.

Similar threads

R
Super C clutch pilot bearing
Replies
7
Views
442
Roger46
R
Z
Farmall 656 transmission overhaul--should I replace bearings if they seem ok?
Replies
7
Views
504
Greg Reed
G
D
Super M transmission
Replies
0
Views
207
Darryl 2Ms
D
M
Farmall H trans input shaft bearings
Replies
2
Views
324
Chester5731
C
L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top