(800) 853-2651
SHOP NOW

H hydro oil check

R

Robin Hood

Member
Please scuse my ignorance. Wondering how to check/change hydro oil in the H we just bought. I did the engine and trans/rear today.

Also, when you fill the cup in the air cleaner assembly, do you fill the outer part, the inner, or both.
Thanks for your help.
 
WElcome to having an H. I think it's one of the best.
"Hydro" Oil; This is called the belly pump, or the Lift-All pump. There's a nice cast iron 2" knurled knob sitting on top of the body of the tractor, on the right side above the belly pump. Just unscrew it and pull out the dip stick. Your owner's manual will tell you more. I use 30W in mine. You fill it thru this same opening.
To change the oil, I have no idea. I'll look and see if I can tell. I usually had leaks in my equipment so changing it was automatic.
Oil Cup; There's holes in the small inside cup, to keep the levels level, so make sure the holes are clean. Then you just fill the whole thing up to the Oil Level line stamped in the body. Use the same oil. You'll see it.
 
My owner's manual shows a pipe plug on the bottom of the Lift-All pump. I just went out and checked, and there's a pipe p;lug there. Like I say, I have never changed mine, it has the automatic-change feature (ha-ha).
I do not know how muchoil it takes. Use the dipstick, and check it when all the pressure is off the system (all implements down.)
 
(quoted from post at 15:57:45 04/20/11) Please scuse my ignorance. Wondering how to check/change hydro oil in the H we just bought. I did the engine and trans/rear today.

Also, when you fill the cup in the air cleaner assembly, do you fill the outer part, the inner, or both.
Thanks for your help.
Click to expand...

There is a drain plug in the bottom of the belly pump. It holds 6 quarts.

Take a good look at your air filter oil cup. You will see it is impossible to fill the inner part without filling the outer part at the same time. If you CANNOT see it, you need to thoroughly clean that oil cup.
 
You must log in or register to reply here.

Similar threads

A
IH 140 antifreeze, oil, oil filter, plugs, points, hyd fluid
Replies
4
Views
258
BarnyardEngineering
BarnyardEngineering
D
Re: Farmall H MW paper air filter
Replies
0
Views
282
DR. EVIL
D
L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
D
Farmall Super H battery box light bracket
Replies
4
Views
340
caterpillar guy
C
D
Ford 4000 PTO Wont Engage
Replies
10
Views
661
Dwilshire
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top