Upon previous postings answers to what seals to buy for the pto housing, I bought 2, as it looked like the housing would take 2. Their numbers, NAPA numbers, is13985, and 13671. I bought them at 2 different times, and maybe from 2 different places. The 13671 is the right size, the other isnt. Too small. My question is. Is a seal all that goes into that housing. What came out of it as origional had springs in it, and was at least 1/2in wide. Do I put 2 modern seals in it to take up the spaceing, or does something else besides a seal go into the housing. Thanks for the help
- Thread starter Farmallb
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy