Super a planter tool bar

MSFARMALL · Mar 30, 2011

Hi fellas, I need some help. I have a Super C 180 planter tool bar that looks identical to the one used on a Super A, but it is not as wide. I need to add some square bar to each end to make it work on my Super A. I need the total width (length) of the square tool bar as well as the distance from each end to the bracket where the planter actually attaches to the tool bar. with these dimensions, I will know how much bar to add to each end. I posted in the classified, hoping someone might have a tool bar for sale, but so far, no luck, so I suppose I will adapt the one I have.

gene bender · Mar 30, 2011

How long and what size is the bar.

Jg20601 · Mar 31, 2011

Not sure I understand the question.

You have a planter for a Super C. Does it hook up to the brackets on the Super A?

Here most toolbars are 6 feet long, with the row spacing dependent on the tractors you use for cultivating..

MSFARMALL · Mar 31, 2011

Gene,This tool bar is only about 29" long, 1 3/4" square, which is not long enough; wide enough, to go underneath the width of my Super A and fit into the cultivator frame sockets. The tool bar looks identical to the one shown in the parts book, part number 516 603 r92,for the Super A, but is just not as wide. My intent is to just add 1 1/2" square bar on each end and then I can center the planter in the tread of the tractor. It would help if someone had this tool bar and they could provide the total length; width of the tool bar and the distance from one end of the tool bar to the bracket where the planter actually attaches. I also have a planter runner that has this tool bar welded to the runner, but it was for my Farmall A. Thanks for any help you may offer.

Super a planter tool bar

MSFARMALL

Member

gene bender

Well-known Member

Jg20601

Member

MSFARMALL

Member

Similar threads