(800) 853-2651
SHOP NOW

Main Seal Update

M

mikeinWA

Member
As promised: a quick update to let you know that the front main seal is out of my SA. A large bearing separator and a bit of patience. The pulley hub does not seem to have a groove that corresponds to the old seal, but does appear slightly flared at the end that is closest to the motor. I have a replacement seal and a bunch of gaskets on the way and will check it against the new seal for fit. The old seal was toast.

Thanks again, this has always been a great sight. i feel a bit guilty to swoop in and grab info but the farm has grown a bit and I just don't find the time to post as much as I used to.

Mike
 
As long as there isnt a grouve where the new seal sets but you say flared so there must be some sear did you put a straight edge over the area where the seal seats. Ive been using s seal there thats for another use its wider and i have had good luck with it doing its job.
 
yeah, I miced it and it is about 5/1000s off. I have a speedy sleave on the way because I just cannot tell if I can fudge the location of the seal enough to get onto a good surface. The disassembly necessary to replace the seal is a motivator to get it right the first time.

Mike
 
You must log in or register to reply here.

Similar threads

Ellis Kinney
PTO seal
Replies
13
Views
646
rustred
rustred
P
Farmall 400 - - rear main seal replacement questions
Replies
3
Views
320
D Slater
D
D
Early 8N oul seal and retainer question
Replies
2
Views
257
Dan
D
W
4020 rear main seal. Who knows
Replies
3
Views
647
T.R.K.
T
N
5 Star rear main seal
Replies
3
Views
660
Caseboy1
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top