(800) 853-2651
SHOP NOW

400 Water pump driver photo request

P

PaddyO

Member
Greetings,

Left the lens cap on when taking this part off tractor! ;) Does anyone have photo of driver and fan and pump assembled using the Eaton pump PS setup? I am unsure where the 5/16 nut (2) goes on longer bolt used in place of driver stud used on non-PS setups.. Would also appreciate a written description too!

Thanks in advance,

Paddy
 
No photo, but put spacer on long bolt, put bolt through driver, then install nut. Tighten nut so spacer is tight, then screw bolt through fan into hub. You may well want a flat washer against the spacer on both ends as well. I know you didn't say anything about spacers but they are supposed to be there for that application.
 
You must log in or register to reply here.

Similar threads

M
1963 4140 HD Industrial 4-cylinder - Need help with powe
Replies
6
Views
843
geok
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top