Melvin C. Thomas,Sr
New User
need info on the correct way to install 2 piece felt rear crankshaft seal.
- Thread starter Melvin C. Thomas,Sr
- Start date
Janicholson
Well-known Member
I pre iol the felt, place it in the groove and pack it pretty tight. The ends will stick out. I cut the ends such that they only stick out 1/8" before the bolts go in. Other opinions may vary. Jim
Melvin C. Thomas,Sr
New User
Thanks Jim:That is the way someone else told me so I am going with that.Thanks again. Melvin
Melvin C. Thomas,Sr
New User
Thanks Jim:Thats what someone else told me this morning so thats what I am going with.Thanks again! Melvin
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy