Framall 450 shifter rebulid

Tony_Idaho · Feb 26, 2011

Hello,
I am looking for the specs for rebuilding the shifter lever, like Jim (Janicholson) mentioned to me. I can only find this picture. It says for a Farmall H

The questions is, does this also apply for a 450? I know Jim mentioned to me that the M and 400 were the same specs as a 450.

If I just missed searching for the correct one, can you please let me have the link to the correct one.

Thanks
Tony

Dblair · Feb 26, 2011

there about the same , I just welded mine up and fitted to the slot.

rustred · Feb 26, 2011

not sure, but i dont think the H is the same as the M. get a measure ment of the rail width and length where it fits and go from there. as long as the bottom of shifter is ground flat and not too wide , that it fits in rail good. might have to try the shifter a few times but you can get it no problem.

GordoSD · Feb 26, 2011

I posted this for you. It was first posted by a forum member named "Neblinc". Anyone know where Randy is hiding out. And did we ever see the end result of that detailed resto he was doing on the H?

Gordo

Brian Schmidt · Feb 26, 2011

I did my 300 with these specs last summer and it worked great. You want a little clearance between that of the slot in the shift arms and the shifter lever. These numbers are right on.

Framall 450 shifter rebulid

Tony_Idaho

Member

Dblair

Well-known Member

rustred

Well-known Member

GordoSD

Well-known Member

Brian Schmidt

Member

Similar threads