H Surging

Moki · Feb 16, 2011

I had my H overhauled a while back and ever since it has a surge at the lower throttle settings. I helped in this overhaul and can't tell if I have the throttle shaft connected to the governor correctly or not. It appears to me that there should be a spring on either side of the pivot point. Do these springs need to be replaced? Is it likely that the carburetor might need adjusting and cleaning? This tractor has done hardly any work in its life and never had the surge before the overhaul. Maybe someone out there has had a similar experience? I had it overhauled because it seemed like a little oil was getting past the rings, etc. It sat a lot during its lifetime on my uncle's farm.

Farmall_H_Puller · Feb 16, 2011

You need to adjust the throttle shaft going from the govenor to the carburetor it is not aligned right. My H did the same thing after I took it off to fix a leak and I moved it up a little bit and it stopped the surging.

Moki · Feb 17, 2011

Thanks, I'll give that a shot on the next warm day. I appreciate your help and insight.

toymaker 27 · Feb 17, 2011

I have a SW6 that surges also. Is this throltle shaft adjusted by turnung the screw next to the carborater body?

H Surging

Moki

Member

Farmall_H_Puller

New User

Moki

Member

toymaker 27

Member

Similar threads