(800) 853-2651
SHOP NOW

Can I remove the PTO assy from a 340?

S

shawnm

Member
I'm wondering if I can remove the PTO assy off of my 340 and operate the tractor? If so is there a factory PTO delete plate available for these?
 
I'm sure there WAS a "factory" plate available, but good luck finding one. You sure aren't going to find it at a CaseIH dealer, unless they just happen to have an NOS one sitting on the shelf for 40 years.

All it is, is a flat piece of steel with approximately 6 holes in it, and a piece of gasket material. Not terribly difficult to make.
 
Ok, thanks.

If possible I want to have the tractor to have a factory plate installed to be safe with the tech officals at our pulls. Removing the PTO allows me to get the drawbar up high enough and back to 18" from the axle center.
 
(quoted from post at 11:18:21 02/14/11) Here is the part number for the IPTO delete cover:

358841R11
Click to expand...

Thanks d282.

Did you get this number from a parts book online? I wonder if I can get one off a 300 or an H? I've been told the rear ends are the same but I haven't had two side by side to compare yet.
 
Maybe off a 300, but definitely not off an H or Super H. The H's have transmission-driven PTOs, not IPTO like the 300 and 340.

The Farmall 504 should have the same IPTO as the 340.
 
If this has the through shaft like the bigger tractors for the PTO drive. I would want the shaft out from the hydraulic pump drive gear back so it doesn"t wind up in the other gears.
 
A cover off of a 300, 330, 350, 400, 450, 460, 544, 560, 656, or 660 will also work as well as a few oddball models as well. Just a four bolt cover and a big o-ring. All covers are the same part number as listed by d282

O-ring is part # 384398R1
O-RING, power take-off opening cover (7-1/8 x 7-17/32 x 13/64")
 
You must log in or register to reply here.

Similar threads

X
340 International Industrial PTO Problems
Replies
1
Views
230
Janicholson
Janicholson
B
Farmall/IHC Seat Questions
Replies
8
Views
319
the tractor vet
T
B
Ford 2000 PTO shaft seal leaking
Replies
2
Views
163
Bennett French
B
B
Farmall 340 Engine
Replies
4
Views
371
gene bender
G
D
PTO removal on RTU
Replies
1
Views
185
montidale
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top