(800) 853-2651
SHOP NOW

560 Dieasel Timing Help?

N

NewHpuller

Member
I had my 560 Diesel pump rebuilt.
I pulled it out at #3 TDC
I gues the rebuilder pulled the shaft to a new degree.
How can i find TDC for #1 Cyl
#1 Cyl is the first by the radiator?
I need some advice.
 
How can i find TDC for #1 Cyl

Timing marks on the crankshaft pulley and the pointer on the front cover.

#1 Cyl is the first by the radiator.


As long as you did not remove the pump drive shaft from the engine you do not need to have the engine set to any particular cylinder. The pump can only be installed two ways. Just match the dimple on the end of the shaft to the dimple in the pump and you will be on the correct cylinder.
 
That sounds to easy.
I must of had it right.
Just would not start.
Any ideas restarting with a new huel sustem & hoses.
 
Try loosening the fuel lines at the injectors and crank it over until you have fuel. with a rebuilt pump there will be alot of air in the system
 
Another way to prime the system once the pump is on if you have another tractor and somebody to help you is crack all the lines open as mentioned than pull it around to prime the lines, can work much easier and faster than cranking engine depending how long its been sitting.
 
You must log in or register to reply here.

Similar threads

W
560 Valve setting
2
Replies
23
Views
929
WHFarms
W
W
560 Hydraulics explained
Replies
13
Views
607
BarnyardEngineering
BarnyardEngineering
L
Farmall 560 Diesel Alternator Conversion
Replies
5
Views
230
used red MN
U
B
Genset with U9 engine mag install
Replies
5
Views
249
Bogbilly
B
R
Oliver Super 77 timing
Replies
3
Views
229
Jim.ME
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top