(800) 853-2651
SHOP NOW

More IH 350 questions

K

Kenneth W

New User
My first question is, on the hyd pump is the filler neck for hyd fluid or is it separate from the pump and used as an oil fill? Lastly, how exactly does the touch control work?
 
The big filler neck by the Hyd pump in the front of the gas engine is for motor oil. the hyd oil fill is a 3/4 or 1" pipe plug plug, slightly up and a little forward of the brake pedals if I remember right. it"s a cast iron reservoir where the hyd pump lines go to, and the hyd control levers, hyd valves and cylinder hose connections are.
 
touch control - if tractor has a fast hitch you would use the outside lever to raise or lower the hitch. the other one or two levers control remote hyd lift cylinders. the hyd control levers are to the right of the steering wheel above the brake pedals. push forward to raise, pull back to lower.
under the right side hood (there may be a hole on top of hood right side) on each hyd control valve is a 1" shaft sticking up on the top of the valve. it has flats for a 3/4" wrench to turn it about 1/4 turn for single acting (one hose) or double acting (two hoses) hyd cylinder operation.
 
Since you called it an IH 350, I'm guessing it might be a 350U (utility)? If so, the hydraulic reservoir is the large casting under the seat. The fill port is on the top surface of that reservoir, kind of on the right front part of it. A 7/8 wrench fits it good, take it out and it should have a dipstick attached to it. The one by the hydraulic pump is, as the other fellow said, for the motor oil.
 
You must log in or register to reply here.

Similar threads

M
1952 Super A Hydraulic pump help
Replies
5
Views
323
BarnyardEngineering
BarnyardEngineering
N
IH 350 hyd. Pump
Replies
2
Views
306
nashranch
N
Slow lane 49
350 Utility rusted shift rails
Replies
10
Views
653
Janicholson
Janicholson
Slow lane 49
350 utility belt change
Replies
6
Views
459
Slow lane 49
Slow lane 49
P
Questions about a Cub. I'm considering
Replies
7
Views
369
BarnyardEngineering
BarnyardEngineering
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top