(800) 853-2651
SHOP NOW

F-20 Crankshaft

as there are no specs listed maybe a better question would be how much have you got? If the crank and bearings look good and you set the rods per the manual you will probably be ok. Dont waste your time and money on plasticguage for this family of engine.
 
If it's worn a lot or is out of round you can have it ground undersize then have your connecting rods rebabbitted to fit the rod journals. Hal

Roberts Bearing Service in Ripley, WV they would need the measurement of the rod journals.

304-372-4136
 
Back in the 1970's I was restoring a StandardTwin garden tractor and my local auto machine shop ground the rod journals undersize and sent the rods to Federal Mogul to be rebbatted. Just had to shim them to get enough clearance. Hal
 
You must log in or register to reply here.

Similar threads

J
8N Engine Rebuild, Crankshaft Question
Replies
14
Views
614
JB8N
J
B
1948 MM UTU 4.625x6.625 Crankshaft help needed!!
Replies
2
Views
362
T.R.K.
T
P
Can I put 730 LP pistons in a 630 engine?
Replies
4
Views
433
used red MN
U
M
My dad's F-20 Farmall
Replies
11
Views
1K
34Case
3
G
HF Die Grinder Thrust
Replies
5
Views
653
Glenn F.
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top